• Contents
• Search

Cordless Installation

1. Attach the base to a silhouette desk phone.
2. Remove the existing base (this one takes its place).

   Once you have a cordless base attached to the silhouette Desk Phone you can no longer daisy chain it to another device.

3. Plug the cradle power cord into an electrical outlet.
4. Insert the included battery into the cordless.
5. Place the cordless on the stand to charge it.
6. You can register the repeater automatically or manually.
   • Auto Registration
     1. Ensure that the repeater is switched off (disconnect the power plug).
     2. Set the base station in registration mode. Press reset key on back of the base.
     3. Switch on the repeater (connect the power plug).

        The LED on the repeater flashes. After a short time the LED stays on permanently indicating that registration is complete and the unit is ready for operation.

        If the registration is not immediately successful, the LED flashes continuously. In this case repeat the procedure.
     4. Before reinstalling the repeater (for example at another base station) reset the repeater as follows:
        1. Switch off the unit (disconnect the power plug).
        2. Switch off the unit for 1-5 seconds and switch on again.
        3. Switch of the unit for 25-35 seconds and switch on again.

           Now the repeater is ready for a new auto registration.

   • Manual Registration

     You need to do this for each repeater and you need a silhouette phone accessible to you to complete this task.

     1. Set the repeater in registration mode
        1. Insert the repeaters power plug for 1-5 seconds in the socket and then remove it.
        2. Insert it once more and leave it there.

           You now have five minutes to carry out the registration. If not complete by this point you must start anew.

        3. Press the reset button on the back of the base to set it in registration mode.

           The LED on the front of the repeater flashes. If the LED flashes very quickly without interruptions, skip the next step. If the LED flashes very quickly with brief interruptions go to the next step.

        4. Register the handset.
           1. If the base code has been changed, you must set it to “0000”.
           2. You must repeat the registration procedure even if the cordless unit was already registered to the base station

              Now the LED flashes very quickly without interruptions.

     2. Assign a repeater number
        1. You must now assign a repeater number to the repeater (select: 2-7 for up to six repeaters).
           Each number can only be assigned once, when using more than one repeater. These numbers are independent of the cordless extension numbers.
        2. Take one of the previously registered silhouette Cordless and Hook Off by pressing the Green Call Button.

           The LED on the repeater stops flashing.

        3. Press a number between 2 and 7.

           When the repeater has accepted the chose number, the LED will flash a corresponding number of times.

        4. Accept the registration by pressing the asterisk [*] key and then the Green Call Button.

           The repeater is now automatically restarted.

           The LED will go off for two seconds, flash for a moment and then will remain constantly illuminated.

           The registration is now complete. You can now disconnect the repeater and move it to the desired location. Disconnecting the power will not delete the registration.

        5. Verification Tone

           The verification tone enables you to establish whether the silhouette cordless is working in the extended area of the repeater. This tone is audible on the activated silhouette cordless as long as the unit is connected to the repeater. To toggle the verification tone, follow this procedure:

           1. Switch off the repeater (disconnect the power plug).
           2. Switch on the repeater for 1-5 seconds and switch it off again.
           3. Switch it on again.

              The LED on the unit is flashing slowly, switch it off again.

           4. Switch it on again.

              The verification tone is then activated or deactivated.