• Contents
• Search

Configure Handsets via IP-DECT Stand Configurator Web Interface

You access the IP-DECT Stand Configurator by entering the IP-address of the handset into the address field on a web browser, such as Internet Explorer on your PC. The following procedure covers the minimum configuration required to set up the handsets:

1. Press the Volume Up key on the side of the 5610 Cordless Handset to enter the system status display.

   The display shows the MAC address of the handset and the IP address of the IP DECT Stand. Note that the Boot Status of the handset is displayed as Failed. Ignore the displayed boot status because it is not accurate.

2. Record the IP address of the DECT stand, which is shown in the display.
   _______________________________
3. Obtain and record the Handset IDs (IPEIs) on each handset.
   1. Press OK to access the main menu.
   2. Select Settings.
   3. Press OK.
   4. Select Handset ID.
   5. Press OK.
   6. The handset IPEI is displayed.
   7. Record the IPEI.
      Handset 1 IPEI: _______________________________
      Handset 2 IPEI: _______________________________
      Handset 3 IPEI: _______________________________
      Handset 4 IPEI: _______________________________
      Handset 5 IPEI: _______________________________
      Handset 6 IPEI: _______________________________
      Handset 7 IPEI: _______________________________
      Handset 8 IPEI: _______________________________
      
   8. Press Back to exit.
4. Launch a web browser on a PC that is connected to the local network.
5. Enter the IP address (for example http://10.10.106.235) of the IP DECT Stand (from Step 2) in the browser address field.
6. At the login screen enter the following default user name and password:
   Username: admin
   Password: admin
   You can reset the stand to the default configuration values (including the username and password) by pressing and holding the RESET button on the IP DECT Stand for more than 10 seconds.
7. Use the menu items in left frame of the web page (see figure below) to configure the DECT stand.